FLITELab AMPJet S 4'8" — Foil Assist Built Into the Board

New but show room display!

The FLITELab AMPJet S 4'8" is the most versatile board in Fliteboard's AMP lineup and the smartest foil assist system on the water right now. Instead of bolting a motor pod to your mast, the AMPJet jet cartridge slides into a sealed cavity inside the tail of the board — centered directly over the lift of your front wing. The result is 25 kg (55 lb) of instant thrust on demand with zero added drag below the waterline, and a board that still rides like a pure, unpowered carbon prone foil board once you are flying.

One setup, three disciplines: prone foil surfing, wing foiling, and downwind foiling. Press the button, get up, then ride clean. Pull the cartridge out, drop in the foam blank, and it becomes a featherweight unassisted foil board with nothing hanging off your mast.

Why the 4'8" Is the One to Buy

The AMP_S range comes in 4'2" (27L), 4'6" (32L), and 4'8" (40L). At 40 liters and 20 inches wide, the 4'8" is the largest and by far the most forgiving of the three. That extra volume and width is what makes it a genuine do-everything board:

  • Easiest knee starts and paddle-ups of the S range — a real advantage when you are learning assisted foiling.
  • Wide enough to wing and parawing, not just prone, so one board covers light-wind wing days and swell missions.
  • Works for riders up to a heavier weight range where the 4'2" and 4'6" get demanding.
  • Still a performance prone shape — the S outline is a surf shape, not a mid-length, so it carves and pumps properly once on foil.

How the AMPJet Actually Works

  • Boost mode: roughly 5 seconds of full thrust at the press of a button — enough to punch into waves you could never paddle into, or to get up on flat water off a bump.
  • Paddle Assist mode: about 60 seconds of low power to push you back out to the lineup without burning your arms.
  • Auto cutoff: the jet shuts off when you lift onto foil, so you stop wasting battery the instant you are flying.
  • Roughly 40 combined boosts and assists on two AMPCells — about a 2-hour session for most riders.
  • Swap in seconds: pop the batteries for a fresh set, or pull the whole cartridge and fit the foam blank for unpowered riding.

AMPJet vs. Mast-Mounted Foil Assist

This is the real reason riders move to the AMP system. A traditional assist unit clamps a motor pod and battery to your mast, adding drag every second you ride, powered or not. The AMPJet lives inside the board:

  • No drag penalty once you are on foil — nothing protruding into the water flow.
  • Minimal swing weight because the mass sits over the front wing's pivot point, so the board stays agile.
  • Your foil stays yours — run any mast and wing setup you like underneath.
  • Nothing to rig on the beach: no straps, cables, or pods to mount before every session.

Weighing your options? Compare it against our Foil Drive assist systems and talk to us — we sell and ride both.

Specifications

Model FLITELab AMP_S 4'8" (AMPJet compatible)
Dimensions 4'8" x 20" x 3.5"
Volume 40 L
Board weight approx. 9.7 lb (4.4 kg), ±5%
Construction Super-stiff carbon layup; AMPJet built from high-grade carbon fibre and polymers with an anodised aluminium impeller on bushes for saltwater durability
Max thrust 25 kg / 55 lb (with 2 x AMPCells; a single AMPCell produces less)
Jet cartridge weight 2.2 kg including impeller
Added system weight approx. 3.5 kg (one AMPCell) to 4.5 kg (two AMPCells)
Battery AMPCell_142 — 142 Wh, approx. 1 kg each, interlocking, under the 160 Wh airline threshold
Charge time approx. 50 minutes per AMPCell on the included charger
Ride modes Boost (~5 sec full power) and Paddle Assist (~60 sec low power)
Session life approx. 40 boosts/assists on two AMPCells (~2 hours typical)
Disciplines Prone foil surfing, wing foiling, downwind foiling, parawinging
Condition Brand new, never ridden

Battery safety: every AMPCell includes an advanced battery monitoring system, phase-change material for thermal headroom, a humidity sensor to detect seal failure, and a sight glass for visual moisture inspection. Airline rules vary — confirm with your carrier before flying.

What's Included

This set covers everything above the water. You add your own mast and foil, so you can keep riding the front wing you already trust.

  • AMP_S 4'8" carbon board
  • AMPJet jet cartridge
  • AMPCell spacer and foam blank cartridge for unpowered riding
  • AMPCell charger
  • AMP_LAUNCHPad controller and charger
  • AMP board bag

Not included: mast, fuselage, front wing, and stabiliser. Call us to confirm current AMPCell battery quantity in this set before you order.

Complete Your AMP Setup

Buy It From People Who Ride It

Elite Watersports is a full-service foiling, wing, and kite shop in St. Petersburg, Florida, on Tampa Bay. We stock foil assist systems, service them in house, and ride them ourselves — so you get an honest answer about whether the AMPJet or a mast-mounted system fits your riding, your weight, and your local conditions. Only one of these 4'8" boards in stock.

Questions or ready to ride? Call or text 727-800-2202, or contact our team. We ship nationwide and offer local pickup and setup in Tampa Bay.

 

You recently viewed

Clear recently viewed